Single screw granulator and power unit to be strong device. If the single screw granulator needs long-term fixed operation, it should be fixed on the cement foundation; If the single screw granulator is required to operate, the unit should be installed on the base made of Angle iron, and ensure that the power machine (diesel engine or motor) and the belt pulley groove of the single screw granulator are in the same reverse plane.
Single screw granulator and power unit to be strong device. If the single screw granulator needs long-term fixed operation, it should be fixed on the cement foundation; If the single screw granulator is required to operate, the unit should be installed on the base made of Angle iron, and ensure that the power machine (diesel engine or motor) and the belt pulley groove of the single screw granulator are in the same reverse plane. After the completion of the single screw granulator device, it is necessary to check the fastening status of the fasteners of each part. If there is loosening, it should be tightened. Check the belt tightness is appropriate. Single screw granulator before starting, first roll the rotor by hand, check the claw, hammer and rotor operation is sensitive and reliable, there is no knock scene in the crushing room, the rotation direction of the rotor is not consistent with the direction of the machine arrow, the power machine and single screw granulator smooth is not outstanding.
Do not replace the pulley at will, in case the speed is too high to cause the blasting of the crushing chamber, or the speed is too low to affect the working power of the machine. Single screw granulator should adhere to its first idling 2~3min after starting, no abnormal scene before feeding operation. In the operation, we should pay attention to the operation status of the single screw granulator at any time. First of all, the feeding should be uniform to prevent the blockage of the crushing chamber. Second, don't overwork for a long time. If it is found that there are oscillations, noises, excessive bearing and body temperature, outward spraying and other phenomena, it should be stopped immediately to check, and the sustainable operation should be carried out after troubleshooting.
