The components of the metal crusher

The reducer motor adopts the direct worm gear reducer motor, which is directly installed on the drive shaft of the pulverizer and transmitted to the driven shaft through the variable speed of the large and small gears, so that the spiral tooth cutter head on the main and slave moving shaft forms relative movement. The spiral tooth cutter head on the main and slave moving shaft is staggered, so that the material enters, and is squeezed, torn and shears at the same time, so that the material is broken. Because most of the metal materials needed to be broken are brittle and hard, the chip breaker inner piece, pinion gear, iron screen and other parts must be made of wear-resistant hard materials such as gold steel. The flywheel is installed on the spindle to make the spindle have greater torque when breaking iron chips. In addition, the spindle is best driven by a hydraulic coupler to eliminate the excessive peak current of the motor and absorb the vibration of the spindle. When the shears are used to break the debris of high wear-resistant materials (such as bearing iron), the surface of the rotor should also be coated to enhance its wear resistance.