The automatic wire stripping machine is actually a type of automatic terminal machine, but it is only aimed at emphasizing the wire stripping function, and some equipment may only have operations such as wire stripping.
Usually, this kind of fully automatic equipment also includes various functions such as punching terminals and wearing plastic shells in addition to the protection and stripping function. Then when we use the automatic wire stripping machine on a daily basis, the wire harness is easy to deviate. How is this problem usually caused?
1. The main control module problem
If there is a problem with the main control module of the fully automatic wire harness stripping machine, it will directly cause the problem of the deviation of the wire harness, and simple debugging is useless, and it is necessary to contact the manufacturer in time to deal with it.
2. Clamping part
There was a fault in the clamping part of the automatic wire harness stripping machine, and various spare parts such as coaxial output were adjusted.
3. The pulling force is too large and too small
If the tension of the wire harness is too large or too small, it may affect the deviation of the wire harness, so it should be debugged according to the correct wire tension comparison table of the automatic terminal machine, and it should be fine-tuned according to the actual situation.
4. Material blocking
The material blockage is actually easy to understand, that is, the speed of the wire harness forwarding is higher than the production speed, and it will pass. If the wire harness is not stretched straight, it will naturally deviate. Too fast, too long tangent time, mismatch, etc. may cause material blockage.
5. Harness quality problems
If the quality of the wire harness is low, it will not be able to correctly correspond to the tension value that it should have.
6. The hose is bent and inclined, and the driving wheel is loose
If the important parts of the wire harness are tilted and loose, it will cause different degrees of deviation. In fact, you can refer to the second point for this, and all need to be adjusted.
